From Linux Man Pages
killpg - send signal to a process group
SYNOPSIS
#include <signal.h>
int killpg(int pgrp, int sig);
DESCRIPTION
killpg() sends the signal sig to the process group pgrp. See signal(7) for a list of signals. If pgrp is 0,
killpg() sends the signal to the sending process's process group.
(POSIX says: If pgrp is less than or equal to 1, the behaviour is undefined.)
For a process to have permission to send a signal it must either be privileged (under Linux: have the CAP_KILL
capability), or the real or effective user ID of the sending process must equal the real or saved set-user-ID of
the target process. In the case of SIGCONT it suffices when the sending and receiving processes belong to the
same session.
RETURN VALUE
On success, zero is returned. On error, -1 is returned, and errno is set appropriately.
ERRORS
EINVAL Sig is not a valid signal number.
EPERM The process does not have permission to send the signal to any of the target processes.
ESRCH No process can be found in the process group specified by pgrp.
ESRCH The process group was given as 0 but the sending process does not have a process group.
NOTES
There are various differences between the permission checking in BSD-type systems and System V-type systems. See
the POSIX rationale for kill(). A difference not mentioned by POSIX concerns the return value EPERM: BSD docu-
ments that no signal is sent and EPERM returned when the permission check failed for at least one target process,
while POSIX documents EPERM only when the permission check failed for all target processes.
CONFORMING TO
SVr4, 4.4BSD (The killpg() function call first appeared in 4BSD), POSIX.1-2001.
RELATED
getpgrp(2), kill(2), signal(2), capabilities(7)
CATEGORY