From Linux Man Pages
resize2fs - ext2/ext3 file system resizer
resize2fs [ -d debug-flags ] [ -S RAID-stride ] [ -f ] [ -F ] [ -p ] device [ size ]
DESCRIPTION
The resize2fs program will resize ext2 or ext3 file systems. It can be used to enlarge or shrink an unmounted
file system located on device. If the filesystem is mounted, it can be used to expand the size of the mounted
filesystem, assuming the kernel supports on-line resizing. (As of this writing, the Linux 2.6 kernel supports
on-line resize for filesystems mounted using ext3 only.).
The size parameter specifies the requested new size of the filesystem. If no units are specified, the units of
the size parameter shall be the filesystem blocksize of the filesystem. Optionally, the size parameter may be
suffixed by one of the following the units designators: 's', 'K', 'M', or 'G', for 512 byte sectors, kilobytes,
megabytes, or gigabytes, respectively. The size of the filesystem may never be larger than the size of the par-
tition. If size parameter is not specified, it will default to the size of the partition.
The resize2fs program does not manipulate the size of partitions. If you wish to enlarge a filesystem, you must
make sure you can expand the size of the underlying partition first. This can be done using fdisk(8) by deleting
the partition and recreating it with a larger size or using lvextend(8), if you're using the logical volume man-
ager lvm(8). When recreating the partition, make sure you create it with the same starting disk cylinder as
before! Otherwise, the resize operation will certainly not work, and you may lose your entire filesystem. After
running fdisk(8), run resize2fs to resize the ext2 filesystem to use all of the space in the newly enlarged par-
tition.
If you wish to shrink an ext2 partition, first use resize2fs to shrink the size of filesystem. Then you may use
fdisk(8) to shrink the size of the partition. When shrinking the size of the partition, make sure you do not
make it smaller than the new size of the ext2 filesystem!
OPTIONS
-d debug-flags
Turns on various resize2fs debugging features, if they have been compiled into the binary. debug-flags
should be computed by adding the numbers of the desired features from the following list:
1 - Print out all disk I/O
2 - Debug block relocations
8 - Debug inode relocations
16 - Debug moving the inode table
-S RAID-stride
The resize2fs program will heuristically determine the RAID stride that was specified when the filesystem
was created. This option allows the user to explicitly specify a RAID stride setting to be used by
resize2fs instead.
-p Prints out a percentage completion bars for each resize2fs operation, so that the user can keep track of
what the program is doing.
-f Forces resize2fs to proceed with the filesystem resize operation, overriding some safety checks which
resize2fs normally enforces.
-F Flush the filesystem device's buffer caches before beginning. Only really useful for doing resize2fs time
trials.
COPYRIGHT
Resize2fs is Copyright 1998 by Theodore Ts'o and PowerQuest, Inc. All rights reserved. As of April, 2000
Resize2fs may be redistributed under the terms of the GPL.
RELATED
fdisk(8), e2fsck(8), mke2fs(8), lvm(8), lvextend(8)
CATEGORY